Digitus DN-95301 - Page 30

This command enables IP Precedence mode.
Format qos qos-advanced ip_precedence
Mode Global Config
1.3) qos qos-advanced none
This command disables qos advanced mode.
Format qos qos-advanced none
Mode Global Config
2) qos cos
This command configures 802.1p priority queue mapping.
Format Qos cos priority <0-7> queue <1-4>
Mode Global Config
3) qos dscp
This command specifies dscp value to queue mapping.
Format qos dscp <0-63> queue <1-4>
Mode Global Config
4) qos port-based
This command configures port-based priority mapping.
Format qos port-based port <WORD>status {enable | disable}
Mode Global Config
5) qos scheduling
Configure qos scheduling mode.
5.1) qos scheduling strict
This command sets to strict priority.
Format qos scheduling strict
Mode Global Config
5.2) qos scheduling wrr
This command sets to Weight Round-Robin.
Format qos scheduling wrr
Mode Global Config
6) qos ip-precedence
This command configures IP precedence queue mapping.
Format qos ip-precedence <0-7> queue <1-4>
Mode Global Config
7) qos wrr
This command configures queue weight for weight round robin.
Format qos wrr weight <1-15> queue <1-4>
Mode Global Config
8) qos dscp-remark
Note: This command only supports on the following switches,
2. 24-Port 100BaseTX + 2 Gigabit combo Layer 2+ Management Switch
4. 24-Port 1000BaseT with 2 shared Gigabit SFP Layer 2+ Management Switch
5. 48-Port 1000BaseT with 4 shared Gigabit SFP Layer 2+ Management Switch
This command is used to change DSCP value if the outgoing packet is an
IP packet. Select an ACL Entry Name as the criterion and then enter New
DSCP Value as the action. Once the criterion is hit, the DSCP value will be
changed.
Format qos dscp-remark acl_entry_name <name> new_dscp_value <0-63>
Mode Global Config
set
1) set IGMP
Layer 2/2+ Management Switch Series 30