authentication type and server parameters.
Format show tacplus
Mode Privileged Mode
telnet
This command telnet the other host.
Format telnet <A.B.C.D>
Mode Privileged Mode
1.7.4.Global Config mode commands
exit
This command is used to exit current shell
Format exit
Mode Global Config
vlan
This command is used to configure vlan
1) vlan add
This command is used to create a new vlan
1.1) vlan add number
This command enter a vlan ID
Format vlan add number <vlan-ID>
Mode Global Config
1.2) vlan add range
This command enter a range of vlan ID
Format vlan add range from < vlan-ID > to <vlan-ID>
Mode Global Config
2) vlan delete
This command remove a existed vlan
Format vlan delete <vlan-ID>
Mode Global Config
3) vlan ingress
This command performs ingress vlan source port membership check
3.1) vlan ingress forward
The command is used to forward frame but don’t learn SA into ARL table
Format vlan ingress forward
Mode Global Config
3.2) vlan ingress drop
This command is used to drop frames violation vid
Format vlan ingress drop
Mode Global Config
3.3) vlan ingress bypass
This command is used to forward frame and learn SA into ARL table
Format vlan ingress bypass
Mode Global Config
4) vlan port
This command is used to configure 802.1Q port parameters for vlans
Layer 2/2+ Management Switch Series 22
To Next Page
Loading...
Need help?
General
