Digitus DN-95301 - Rmon-Counter

This command storm control limited value :
0,64,256,1024,10240,65536.102400,1024000,which the unit is Kbps and 0
means no limit.
Format storm-control broadcast-multicast <rate>
Mode Interface Config
4) storm-control broadcast-unknown
This command storm control limited value :
0,64,256,1024,10240,65536.102400,1024000,which the unit is Kbps and 0
means no limit.
Format storm-control broadcast-unknown <rate>
Mode Interface Config
e.g. Switch(Interface 1)# storm-control broadcast-unknown 64
5) storm-control all-cast
This command storm control limited value :
0,64,256,1024,10240,65536.102400,1024000,which the unit is Kbps and 0
means no limit.
Format storm-control all-cast <rate>
Mode Interface Config
rmon-counter
This command specifies rmon counter capability on a port
Format rmon-counter {enable | disable}
Mode Interface Config
set igmp-router-port
This command specifies igmp router port .
Format set igmp-router-port {enable | disable}
Mode Interface Config
spanning tree
1) spanning-tree cost
This command configure RSTP port path cost, path cost
value:0~200000000.
Format spanning-tree cost <pathcost>
Mode Interface Config
2) spanning-tree edge
This command configure edge property
Format spanning-tree edge {enable|disable}
Mode Interface Config
e.g. Switch(Interface 1)# spanning-tree edge enable
3) spanning-tree force-p2plink
This command configure force point to point link mode.
Format spanning-tree force-p2plink {auto|enable|disable}
Mode Interface Config
4) spanning-tree migration-check
This command re-checks the appropriate BPDU format to send on this port
Format spanning-tree migration-check {enable|disable}
Mode Interface Config
5) spanning-tree mst
This command configures multiple spanning tree instance.
5.1) spanning-tree mst cost
Layer 2/2+ Management Switch Series 44