This command configure poe function on a port
Format poe func {enable | disable}
Mode Interface Config
2) power-pri
This command configures the power priority on switch ports to decide which
ports have priority to supply power which power devices are connected.
Legal value are low, normal, middle or high priority. If the same power
priority on the ports, the lower port index the higher power priority.
Low Set to low priority
Normal Set to normal priority
Middle Set to middle priority
High Set to high priority
Format poe power-pri level {low | normal | middle | high}
Mode Interface Config
3)detection
This command configures detection type on a port. set to 0,1,2,3,4 or 5
0 No Detection
1 Legacy Capacitive Detection only
2 IEEE 802.3af 4-Point Detection only (Default)
3 IEEE 802.3af 4-Point followed by Legacy
4 IEEE 802.3af 2-Point only
5 IEEE 802.3af 2-Point followed by Legacy
Format poe detection type {0 | 1 | 2 | 3 | 4 | 5}
Mode Interface Config
4)high-power
This command configures power Energy Mode on a port
on Start High Power (Support 30W power device)
off End High Power Mode (Support 15.4W power device)
Format poe high-power status {enable | disable}
Mode interface Config
Layer 2/2+ Management Switch Series 46
To Next Page
Loading...
Need help?
General
