This command display all switch interfaces’ cos settings
Format show qos port-based all
Mode Privileged Mode
2) show dot1x
This command display dot1x information
2.1) show dot1x config
This command display dot1x and port configuration
Format show dot1x config
Mode Privileged Mode
2.2) show dot1x radius
This command display radius configuration
Format show dot1x radius
Mode Privileged Mode
2.3) show dot1x statistics
This command display dot1x statistics
Format show dot1x statistics
Mode Privileged Mode
3) show igmp snooping
This command display IGMP snooping information
3.1) show igmp snooping dynamic_router_port
This command display dynamic router ports information
Format show igmp snooping dynamic_router_port
Mode Privileged Mode
3.2) show IGMP snooping groups
This command is used to display igmp groups information
Format show IGMP snooping groups
Mode Privileged Mode
4) show interface
This command is used to display summary statistics
4.1) show interface history
This command is used to display port RX and TX
Format show interface history <port-ID>
Mode Privileged Mode
4.2) show interface statistics
This command is used to display port summary statistics
Format show interface statistics <port-ID>
Mode Privileged Mode
5) show lag
This command is used to display link aggregation groups information
5.1) show lag lag-index
This command is used to specify an switch lag
Format show lag lag-index <port-ID>
Mode Privileged Mode
5.2) show lag all
This command is used to display all switch lag
Format show lag all <port-ID>
Mode Privileged Mode
6) show lldp
This command is use to display lldp statistics
6.1) show lldp statistic
This command is used to display lldp statistic
Layer 2/2+ Management Switch Series 17
To Next Page
Loading...
Need help?
General
