Mode Global Config
6.6) access-list name <WORD> set mac-mode ether-type
This command specifies the ether type of the packet.
Format access-list name <WORD> set mac-mode ether-type {ipv4|
ARP|xns}
Mode Global Config
7) access-list name <name> set portlist
Note: This command only supports on the following switches,
2. 24-Port 100BaseTX + 2 Gigabit combo Layer 2+ Management Switch
3. 48-Port 100BaseTX + 4 1000BaseT with 2 shared Gigabit SFP Layer 2+
Management Switch
4. 24-Port 1000BaseT with 2 shared Gigabit SFP Layer 2+ Management Switch
5. 48-Port 1000BaseT with 4 shared Gigabit SFP Layer 2+ Management Switch
This command is used to specify an acl entry to be work on a list of ports.
Format access-list name <name> set portlist <LINE | port_id>
Mode Global Config
arp
Note: This commands only support on 24-Port 1000BaseT with 2 shared Gigabit
SFP Layer 2+ Management Switch / 48-Port 1000BaseT with 4 shared Gigabit SFP
Layer 2+ Management Switch models.
1) arp dynamic
1.1) arp dynamic enables and disables.
This command enables and disables dynamic arp functions.
Format arp dynamic {enable|disable}
Mode Global Config
1.2) arp dynamic aging-time
This command set arp dynamic aging-time between 0s and
999s.”0”means disable.
Format arp dynamic aging-time <0~999>
Mode Global Config
1.3) arp dynamic ports
This command set dynamic arp ports to trust and un-trust.
Format arp dynamic ports {trust|untrust} <port-list>
Mode Global Config
e.g. Swtich<Config># arp dynamic ports trust 1-4
Swtich<Config># arp dynamic ports untrust 4
1.4) arp dynamic vlan
This command set add/remove dynamic arp on specified vlan.
Format arp dynamic vlan {add|remove} from < vlan -id> to < vlan -id>
Mode Global Config
e.g. Swtich<Config># arp dynamic vlan add from 1 to 1
Swtich<Config># arp dynamic vlan remove from 1 to 1
2) arp static command
This command set arp static address table for mac address with IP
Address.
Format arp static {add|delete} vid <1~4094> ip <A.B.C.D> mac <mac-
address>
Mode Global Config
dos
Layer 2/2+ Management Switch Series 39
To Next Page
Loading...
