培训手册 Training Manual
安全规则 Safety Regulation
JCPT- DCS
www.cndingli.com
1-9
Do not operate a machine in the path of any crane or moving overhead machinery unless the
controls of the crane have been locked out and/or precautions have been taken to prevent any
potential collision.
No stunt driving or horseplay while operating a machine.
Do not lower the platform unless the area below is
clear of personnel and obstructions.
根据地面状况、拥塞程度、坡度、人员位置、和可
能引起碰撞的任何其它因素，限制行进速度。
Limit travel speed according to the condition of the
ground surface, congestion, slope, location of
personnel, and any other factors which may cause
collision.
部件损坏的危险（Component Damage Hazard）
不能使用任何大于24V的蓄电池充电器给蓄电池充电。
不要在焊接时将机器用作地线。
Do not use any battery charger greater than 24V to charge the batteries.
Do not use the machine as a ground for welding.
爆炸和起火危险（Explosion and Fire Hazard）
不能在可能存在易燃或易爆气体或微粒的地方，使用机器或给机器充电。
Do not operate the machine or charge the batteries in hazardous locations where potentially
flammable or explosive gases or particles may be present.
机器损坏的危险（Damaged Machine Hazard）
不能使用已经损坏或有故障的机器。
在每次换工之前，应彻底进行机器操作前检查，并测试所有功能。已损坏或有故障的机器应立
即加上标志，并停止操作。
确保已按照本手册中的规定进行了所有维护操作。
确保所有标贴位置适当且易于识别。
确保本手册保存在平台中的手册盒内。
Do not use a damaged or malfunctioning machine.
To Next Page
Loading...
Need help?
General
