培训手册 Training Manual
安全规则 Safety Regulation
JCPT- DCS
www.cndingli.com
1-11
The battery tray should remain open during the entire charging cycle.
Do not contact the battery terminals or the cable clamps with tools that may cause sparks.
部件损坏的危险（Component Damage Hazard）
不能使用任何大于 24V 的蓄电池充电器给蓄电池充电。
Do not use any battery charger greater than 24V to charge the batteries.
电击/烧伤危险（Electrocution/ Burn Hazard）
只能将蓄电池充电器连接到已接地的交流三线电源插座上。
每日检查线缆、电缆和接线是否有损坏。操作前更换已损坏的物件。
避免由于与蓄电池端子接触而遭受电击。摘掉所有的戒指、手表和其它饰
品。
Connect the battery charger to a grounded, AC 3-wire electrical outlet only.
Inspect daily for damaged cords, cables and wires. Replace damaged items before operating.
Avoid electrical shock from contact with battery terminals. Remove all rings, watches and other
jewelry.
倾翻危险（Tip-over Hazard）
不能使用重量小于原装蓄电池的蓄电池。蓄电池在底盘中不仅起配重作用，而且对保持机器的稳定
性至关重要。
Do not use batteries that weigh less than the original equipment. Batteries are used as
counterweight and are critical to machine stability.
提升时的危险（Lifting Hazard）
提升蓄电池时，请使用适当的人数和提升方法。
Use the appropriate number of people and proper lifting techniques when lifting batteries.
每次使用后锁定（Lockout after Each Use）
1) 选择一个安全停放位置，可以是坚实的水平地面，没有障碍物并避开运输繁忙的地方。Select
a safe parking location - firm level surface, clear of obstruction and traffic.
2) 降低平台。Lower the platform.
3) 将钥匙开关转至“关”位置并拔掉钥匙，以避免未经授权的使用。Turn the key switch to the
off position and remove the key to secure from unauthorized use.
4) 用楔子垫住车轮。Chock the wheels.
5) 给蓄电池充电。Charge the batteries.
To Next Page
Loading...
Need help?
General
