培训手册 Training Manual
安全规则 Safety Regulation
JCPT- DCS
www.cndingli.com
1-3
要考虑强风或阵风对平台的移动、电线的摆动及松弛的影响。
如果机器接触到带电的电线时，请远离机器。切断电源前，禁止地面或平台上的人员触摸或操作机
器。
有闪电或暴风雨时不要操作机器。
不要在焊接时将机器用作地线。
Allow for platform movement, electrical line sway or sag and beware of strong or gusty winds.
Keep away from the machine if it contacts energized power lines. Personnel on the ground or in
the platform must not touch or operate the machine until energized power lines are shut off.
Do not operate the machine during lightning or storms.
Do not use the machine as a ground for welding.
倾翻危险（Tip-over Hazard）
平台上的人员、设备和材料不得超过平台及延伸平台的最大承载量。
Occupants, equipment and materials must not exceed the maximum platform capacity or the
maximum capacity of the platform extension.
平台缩回 Platform retracted 平台延伸 Platform extended
仅延伸平台 仅限平台
Extension only Platform only
最大承载量（Maximum capacity）— JCT0607DCS
最多容纳人员数（室外）Maximum occupants (Outdoor use) 1 (CE)/2（ANSI）
最多容纳人员数（室内）Maximum occupants (Indoor use) 2（CE/ANSI）
平台最大工作载荷 Platform allowable maximum load 240 kg
延伸平台最大工作载荷 Extension deck allowable maximum load 100 kg
To Next Page
General
