培训手册 Training Manual
安全规则 Safety Regulation
JCPT-DCS
www.cndingli.com
1-2
设计用途（Intended Use）
此机器的用途仅限于将人员及其工具和材料提升到空中工作场所。
This machine is intended to be used only to lift personnel, along with their tools and materials to
an aerial work site.
安全标识维护（Safety Sign Maintenance）
更换任何丢失或损坏的安全标识，使操作者时刻牢记安全。使用中性肥皂和清水清洗安全标识。请
勿使用溶剂型清洁剂，因为这样的清洁剂可能损坏安全标识的材料。
Replace any missing or damaged safety signs. Keep operator safety in mind at all times. Use
mild soap and water to clean safety signs. Do not use solvent-based cleaners because they may
damage the safety sign material.
电击危险（Electrocution Hazard）
本机器并不绝缘，并且在接触或靠近电线时不提供
触电保护。
This machine is not electrically insulated and will
not provide protection from contact with or
proximity to electrical current.
按照适用的政府法律法规和下表说明，保持与电源
线及电力设备间足够的安全距离。
Maintain safe distances from electrical power lines and apparatus in accordance with applicable
governmental regulations and the following chart.
电压/Voltage
Phase to Phase
最小安全距离(米)/Minimum Safe Approach Distance
Meters
0～300V 禁止触摸/Avoid Contact
300V～50kV
3.05
50kV～200kV
4.60
200kV～350kV
6.10
350kV～500kV
7.62
500kV～750kV
10.67
750kV～1000kV
13.72
To Next Page
General
