DINGLI JCPT DCS Series - 退出速度调节状态并保存操作

培训手册 Training Manual
参数调整 Parameter Adjustment
JCPT- DCS
www.cndingli.com
4-5
1.6 退出速度调节状态并保存操作（Quit the speed adjustment and Save）
图示(Graphic) 说明(Instruction)
1. 瞬间按下“起升”或“行走”按钮，且起升和行走LED显示
全部关闭；
(Press the “Lift” and “Drive” buttons until the LEDs are
off；)
2. 数码管“
”和“ ”交替显示；
(“
” and“ ”alternately displayed；)
3. 按下“喇叭”和“手柄DEADMAN”,快速松开，直到蜂鸣
提示结束，参数保存；
(Press “Horn” and “Deadman” buttons very quick and the
adjustment is saved after alarm over；.)
4. 参数保存成功后，数码管显示电池百分比状态；
(Displays battery percentage after done；)