培训手册 Training Manual
目录 Contents
JCPT-DCS
www.cndingli.com
ii
2. 工作场地检查（Workplace Inspection） .......................................................................... 3-3
3. 功能测试（Function Tests） ............................................................................................ 3-4
参数调整 Parameter Adjustment ........................................................................... 4-1
1. PCU 进入速度调节状态（Speed Adjust State） .............................................................. 4-2
1.1 行走高速（收拢状态）（Drive High Speed with Platform Stowed） ...................... 4-2
1.2 行走低速（Drive Low Speed） ............................................................................... 4-3
1.3 提升后行走速度（Drive Elevated Speed） ............................................................. 4-3
1.4 起升速度（Lift Speed） .......................................................................................... 4-4
1.5 转向速度（Steering Speed） .................................................................................. 4-4
1.6 退出速度调节状态并保存操作 ................................................................................. 4-5
2. PCU 操作功能选择模式 .................................................................................................... 4-6
2.1 PCU 进入功能选择操作状态 ................................................................................... 4-6
2.2 LMI 称重功能激活与关闭 ......................................................................................... 4-7
2.3 防夹手功能激活与关闭 ............................................................................................ 4-7
2.4 车型选择功能 .......................................................................................................... 4-8
2.5 退出功能选择状态并保存 ........................................................................................ 4-9
元器件介绍 Parts Introduction ............................................................................... 5-1
电气原理图 Electrical Schematic ........................................................................... 6-1
液压原理图 Hydraulic Schematic .......................................................................... 7-1
报警代码及解决办法指导 Fault Code with Troubleshooting ................................ 8-1
常规保养 Daily Maintenance .................................................................................. 9-1
1. 液压油更换（Hydraulic oil change） ................................................................................ 9-2
2. 电池的维护（Maintenance of battery） ............................................................................ 9-3
3. 滑块和滑槽的保养（Slider & Spout maintenance） ......................................................... 9-4
To Next Page
General
