培训手册 Training Manual
元器件介绍 Parts Introduction
JCPT- DCS
www.cndingli.com
5-3
序号
No
元器件
Parts
描述
Description
6
压力传感器
Pressure sensor
实时监测剪叉起升的压力，并配合剪叉上的角度传感器，
来实现超载报警并限制起升状态行走和起升的功能。
Check the hydraulic pressure when you lift the scissor all
the time;together work with angle sensor in scissor stack
to get overload function which to limit drive and lift
function in elevated position.
7
坑洞保护开关
Pot-hole switch
控制在起升状态慢速行走，收拢状态高速行走。实现当起
升状态两侧坑洞开关没有打开状态的报警并限制行走和起
升的功能。
To control low drive speed in elvated position and high
drive speed in lowest position；the machine will warn
and limit drive and lift function if the pothole switches are
not activited in elevated position.
8
蓄电池
Battery
2×12V/85AH，牵引电池
2×12V/85AH，Traction battery
9
驱动电马达
Electric Drive Motor
2×24VDC/0.4KWW，
10
电磁阀组
Manifold
控制起升和转向
Control the Lift and Steering
To Next Page
Loading...
