Dionex UltiMate 3000 - Page 19

UltiMate 3000 Nano and Cap - System Installation and Application
15
The following flow splitters and flow cells are available:
Description Part No.
Splitter cartridge (standard) for nano HPLC applications
(split ratio 1:1000)
6720.3150A
Splitter cartridge (standard) for nano HPLC applications
(split ratio 1:300)
6720.3155A
Splitter cartridge (standard) for capillary HPLC applications
(split ratio 1:100)
6720.3160A
Splitter cartridge (standard) for capillary HPLC applications
(split ratio 1:15)
6720.3165A
Splitter cartridge (standard) for micro HPLC applications
(split ratio 1:6)
6720.3170A
Splitter cartridge (biocompatible) for nano HPLC applications
(split ratio 1:1000)
6721.3150A
Splitter cartridge (biocompatible) for nano HPLC applications
(split ratio 1:300)
6721.3155A
Splitter cartridge (biocompatible) for capillary HPLC applications
(split ratio 1:100)
6721.3160A
Splitter cartridge (biocompatible) for capillary HPLC applications
(split ratio 1:15)
6721.3165A
Splitter cartridge (biocompatible) for micro HPLC applications
(split ratio 1:6)
6721.3170A
Flow cell for nano HPLC applications 6074.0270
Flow cell for capillary HPLC applications 6074.0280
Flow cell for micro HPLC applications 6074.0290
For nano HPLC applications, the inner diameter of the capillaries is
20 µm.
For capillary HPLC applications, the inner diameter is 50 µm.
For micro HPLC applications, the inner diameter is 75 µm. If the back
pressure generated by the connecting tubing is too high, tubing with an
inner diameter of 130 µm can be used.
For applications with Monolithic columns with an inner diameter of
100 µm, the inner diameter of the connecting capillaries is 20 µm.
For applications with Monolithic columns with an inner diameter of 200
µm, the inner diameter of the connecting capillaries before the column is
50 µm. After the column, Dionex recommends an inner diameter of
20 µm.