40
© 2009 Directed Electronics. All rights reserved.
8 2nd STATUS OUTPUT—
NORMAL
/LATCHED/PULSED: If pro-
grammed to status mode, this output turns on when the remote start is
activated. This output can be programmed as a Latched or Pulsed out-
put and can be used to activate the rear defroster when the vehicle is
remote started. When programmed to the latched output the status only
stays active for 10 minutes. When programmed to the pulsed output
the status sends out a single pulse. When programmed for the latched
or pulsed mode the output activates 10 seconds after the remote start
is running.
9 ANTI-GRIND
ON
: With the anti-grind On (default) the ground-when-
locked output will be active during remote start operation. This activates
an optional relay and prevents the customer from re-cranking the car
with the key, when doing key takeover. If accessories such as a voice
module or window module are added to the unit, it may be necessary
to use the two-honk setting to program this feature OFF.
10 WAIT-TO-START TIME
OFF
/15, 30, 45 SECONDS: The diesel
wait-to-start timer default is in the OFF setting. When programmed ON
the onboard timer can be set for 15, 30 or 45 seconds.
11 RUN TIME (TIMER MODE)—
0
, 3, 6, 9 MINUTES: Selects the time
in minutes that the system will operate the engine until the system “times
out”. This is the maximum operation period and the system may be shut
down using a shutdown at any time.
To Next Page
Loading...
Need help?
General
