Page 12
You have successfully completed the module programming sequence.
3
2
1
Once the configuration is completed, reconnect the module.
The LED turns ON solid green for 3 seconds, then turns off.
Click on Submit Key2GO Request.
Remove the module from the vehicle and reconnect it to your computer. The XpressKit web site will
automatically recognize that you are moving onto the second phase of the programming sequence.
Refer to the LED Diagnostics section on page 17 for more information and for troubleshooting purposes.
Version 4.5 or higher of XpressVIP must be installed on your computer to complete this programming sequence.
Web Programming (for Key2GO)
Solid x3 Secs
&
Off
6
Leave ignition ON until LED starts flashing orange slowly.
Then press and hold PTS (Push-to-Start) button to turn ignition OFF.
7
Disconnect the module and complete the Key2GO programming.
Flashes
Slowly
5
Press and hold PTS (Push-to-Start) button to turn ignition ON.
LED flashes green.
ENGINE
START
STOP
PUSH
Flashes
&
Rev.: 20140916
Platform: DBALL/DBALL2
Firmware: GM9 Remote Start Ready (RSR) Installation
© 2014 Directed. All rights reserved.
To Next Page
Loading...
Need help?
General
