Directed DBALL User Manual

1
2 3
4 5 6 7 8 9
10 11 12 13 14 15 16
17 18 19 20 21
22 24 25 2623
Page 8
Installation Type 2
[1] This connection is only required when the EIPS (Engine Idle Protection System) feature is activated.
1 2 3 4
5
6 7 8
9 10
17
23
16
22
11
12
18
24
13
19
25
14
20
26
15
21
27
1 2 3 4
5
8 9 10 11 12 13 14
15
21
17 19
23 25
16
22
18
20
24
26
6 7
15
21
17
19
23
16
22
18 20
24
26
8 9 10 11 12 13 14
1 2 3 4
5
6 7
P#: XKD2D65
TX
(-) Ground
RX
(+)12V
10
RF
Prog. Button
LED
4
14 12
2
DBALL/
DBALL2
Single Wire CAN: Light Green: 1
SW CAN:
pin 23
HSCAN Low:
pin 24
HSCAN High: pin 25
Brake:
pin 7
PTS:
pin 17
Immo. Data:
pin 2
HSCAN High: Tan/Black: 3
HSCAN Low: Tan: 4
Brake Output: Yellow/Red: 11
(-) Ground: Black: 14(-) Ground
(+) 12V: Red: 13
(+) 12V
[1](-) EIPS/Horn Output: Red/Black: 4
PTS: Violet/Brown: 9
(-) Parking Lights:
pin 22
1
8 9
10 11 12 13 14
17
23
15
21
16
22
18
24
19 20
25
2 3 4 5 6 7
1kΩ
Refer to "Vehicle Wiring Reference Chart - Type 2" on page 9 for more information on vehicle-specific connections.
White - from BCM
Green - from BCM
Blue - from BCM
Brown - from BCM
Gray - from BCM
5V Reference:
pin 13
Hood Pin
Remote Start Safety
Override Switch
6: White/Black: (-) Hood
BCM (under driver-side dash)
BrownBlue
Green
Gray
White
(-) Parking Light: Black/White: 1
Immo. Data (conn. side): Yellow/Black: 10
Immo. Data (conn. side): Yellow: 8
Immo. Data (vehicle side): Orange/Yellow: 9
5V Reference Input: Brown/Red: 12
[1](-) EIPS/Horn: pin 19
With the exception of the OBDII Diagnostic connector, all adapters are displayed from the wire side (unless specified otherwise).
Rev.: 20140916
Platform: DBALL/DBALL2
Firmware: GM9 Remote Start Ready (RSR) Installation
© 2014 Directed. All rights reserved.

Directed DBALL Specifications

General

Brand	Directed
Model	DBALL
Category	Automobile Accessories
Language	English