37
DS4+ VW10
© 2017-11-02 Directed. All rights reserved.
Module programming
Refer to "LED diagnostics and troubleshooting" on page 38 for more information and for troubleshooting purposes.
To connect the module:
1
Please ensure that the vehicle is in a safe location and cannot move forward during
programming. For vehicles equipped with a manual transmission, make sure the gearshift
lever is in the neutral position.
2
Connect all the harnesses to the DS4+, EXCEPT the 12-pin main power harness.
Connect all but the
12-pin harness
3
Connect the 12-pin main power harness, and wait until the LED turns ON solid red.
Must be
connected LAST
&
Solid
4
Press Unlock on the OEM fob then insert key into key switch and turn ON. The LED flashes
green.
OFF
START
I
G
N
&
Flashes
green
5
Wait for the LED to turn solid green for 3 seconds then OFF.
Solid
x 3 secs
&
Off
6
Turn vehicle ignition OFF once the module is successfully programmed.
OFF
START
I
G
N
7
Pair remotes (if applicable). For information on how to pair a specific remote, please
refer to its corresponding owner documentation, which can be found inside the product
packaging of the complete system or on www.directechs.com.*
Pair
remotes*
8
By default, the tachometer is preprogrammed for the vehicle. For instructions on how to
program tach, see page 41.
Initialize
tachometer
* Your aftermarket remote may differ from the model shown in the illustrations.
You have successfully completed the module programming sequence.
To Next Page
Loading...
Need help?
General
