4
DS4+ VW10
© 2017-11-02 Directed. All rights reserved.
Introduction
The VW10 firmware for DS4+ is compatible with specific Volkswagen and Audi vehicles. It is a complete
solution for remote start, security (when security features are enabled), bypass, and features built in Bluetooth
4.0 allowing you to configure and control your system. This guide provides information on the installation of
the module using VW10. Please refer to the DirectLink application or www.directechs.com for more information
about which configuration is best for your application.
Warning! This module is designed to be configured using the DirectLink application for mobile devices, however it can also
be configured using the web tool located at www.directechs.com. To download the DirectLink mobile application, please visit the
Google Play or Apple store.
Pre-installation and application warnings
Firmware notes: This section highlights important information for this specific firmware and will assist in
pricing accordingly, as well as bringing awareness to any operational or vehicle limitations.
T-Harness
compatible
Keys required for
programming
1
Keys required for
operation
1
Unless specified otherwise, all connectors are displayed from the wire side, with the exception of the OBDII diagnostic
connector.
It is important to check that the fuses are positioned correctly in the module. Refer to the "Fuse selection" section following
each installation type for more information.
Refer to the "Vehicle wiring reference chart" following each installation type.
General notes: This section highlights important information for this specific firmware.
[1] The installation of an aftermarket hood pin is ONLY required on vehicles that are not equipped with a factory hood pin.
[2] The siren is ONLY required when enabling the security features during module flashing.
[3] For Key Wrap instructions, refer to pages 33 & 34.
[4] Locks and trunk release output ONLY required if door locks or trunk are not supported in data.
[5] Diodes and brake connection only required on vehicles where brake needs to be depressed to start.
Additional parts required (maximum required):
2 x 1A Diodes
86 85
30
87a
87
2 x Relay
0 x Resistor
2 x Fuse
To Next Page
Loading...
Need help?
General
