Rev.: 20 708115
Platform: DBALL2
Firmware TL6:
© 201 Directed.7 All rights reserved.
Page 3
How to Know if the Vehicle is Equipped with an Remote StarterOEM
1- An “ ”ENGINE STARTER
sticker should be on the remote.
2- Remote start the remote starter:OEM
Press the remote control’s lock button twice within 2 seconds,
then press and hold the lock button for 3 seconds.
The parking lights flash after 3 seconds. The engine starts and
the parking lights flash repeatedly for 20 seconds.
ENGINE
STARTER
x2 &
Press & Hold
for 3 seconds
Important Remote Starter InformationOEM
If the vehicle is equipped with a physical add-on Lexus/Toyota OEM Remote Starter:
The factory remote starter must be permanently disconnected before programming the Directed interface as both
modules cannot coexist. See locating the OEM Remote Start on .the next page
If the vehicle is equipped with a BCM enabled Lexus/Toyota OEM Remote Starter:
The vehicle does not have a physical remote starter and only one module can be programed at a time. In this case
temporally disable the OEM remote start system using the following process:
1. Remove the fuse powering the OEM Remote Starter.
See locating the fuse powering the OEM Remote Starter on .the next page
2. Perform a module reset, see .« » sectionModule Reset
3. Perform the Module Programming steps ., see « » sectionModule Programming
After progra ming is successful replace the fuse powering the OEM Remote Starter.m
To Next Page
Loading...
Need help?
General
