13
Remote Controls
Switching Between Dual and Single Mode
Put your DISH receiver in Single or Dual Mode by pressing the front panel MODE button.
Keep the following items in mind when switching the satellite TV receiver between Dual
and Single Mode:
Note: If you press the MODE button on the front panel and someone is viewing a remote
TV while the receiver is in Dual Mode, you will see a pop-up message on the nearby TV
warning you that you are about to disrupt the use of the TV2 output(s).
REMOTE CONTROLS
The two remote controls give you access to all the features of your satellite receiver. You
can set up each remote to control the satellite receiver and up to three other devices (see
page 61). These devices can be a TV, a VCR or DVD player, and a third (AUX) device.
This section describes how to use the various features on the two types of remote controls
included with your satellite TV system.
Dual Mode Single Mode
Indications
Dual Mode front panel
indicator lights.
Single Mode front panel
indicator lights.
Favorites
Lists
Favorites Lists that are set
up for both outputs (TV1 and
TV2) are available at their
respective TV locations.
Only Favorites Lists that
are set up for TV1 are
available. The lists for TV2
are not lost, they are simply
unavailable in Single Mode.
Parental
Controls
Locks that are set up for
both outputs (TV1 and TV2)
are available at their
respective TV locations.
Locks that are set up for
only TV1 are available. The
locks for TV2 are not lost,
they are simply unavailable
in Single Mode.
Closed
Captioning
Closed Captioning (CC) for
SD and HD programming is
available on TV1. CC only
for SD programming is
available on TV2 (CC also
must be enabled on the TV
itself).
CC that is set up on the
receiver is available on
both outputs (TV1 and
TV2).
To Next Page
Loading...
