72
Sending Discrete Power On and Off
Removing the Recover Button Channel Programming
The following instructions describe how to reset RECOVER to restore satellite TV viewing
by tuning your TV(s), or VCR if one is installed, to channel 3, 4, and then other inputs.
SENDING DISCRETE POWER ON AND OFF
Installers use discrete power-on and power-off IR commands when programming macro
commands into universal remote controls. Using an on-only or off-only remote command
is more effective than a toggle on/off command when trying to make sure the satellite
receiver is reliably in one state or the other. To use discrete power commands, complete
the following tasks:
To Next Page
Loading...
