dixell xweb 5000 - Identification; Time; Server Property; Alarms; Configuration Menu

XWEB5000 Operation Manual
28/115
1592010600
3.2.3 IDENTIFICATION / TIME
 Name
 Description
These items represents the name of server and its description.
 Time
Clock read-out of the server (internal Real Time Clock).
 Synchronism
To synchronise XWEB real time clock with the value of an atomic clock available on internet, click on Synchro
button:
 The XWEB must reaches the remote time server. To allow this check your network configuration
or setup a dial-up connection to internet. Ask your network administrator.
3.2.4 SERVER PROPERTY
 Operative System Version Linux version
 Resources Level of used memory
 IP adr Address of the server
 CPU temp Internal temperature to use as a diagnostic value.
 Readout RS485 activity
 Recording Recording activity
 Alarm transmission Transmission status
 Average cycle time Time to complete the instrument reading
 Remote connection Connection status
 Last connection Time and date of the last connection
It is important that CPU temperature does not overheat above 77°C (170°F). When this happens the
temperature value is displayed in red colour. Please check the correct fan functioning and the environment
temperature, if XWEB usually has an overheat CPU. Standard environmental values must be between 0°C
(32°F) and 40°C (104°F).
3.2.5 ALARMS
This area immediately shows the system or the instrument active alarms detected during the connection.
The alarm list is repetitively updated in short time intervals.
To manually force the alarm updating: click on the “No alarm ..”
3.3 CONFIGURATION MENU
In this menu you can find all the web pages that allow the final user to interact with the XWEB system setup.
Moreover the user can properly setup controllers‟ behaviour, start/stop acquisition, etc…