dIXEL
Manual de operare Xweb5000
Click on “new”;
Wait the screen refresh.
To delete all the items of the list
Click on “Cancel All”;
Confirm the operation if necessary. Wait the screen refresh.
3.3.2.2 RECORDING INTERVAL
Define the recording intervals
of the instruments to log the
data into the “Main archive”.
Eg: “Standard = 15min.”, “Fast
= 3min.”.
XWEB can define different log
intervals for different
instruments when the log
frequency is not the same for
all the instruments.
To insert a new item
Click into the field “Name” and insert the word or the words that more represents the application;
The most common category should be set as “Default” by clicking into its box; It helps to save time for
most part of the instruments.
Only one “Default” can be selected for this category;
Click “Insert” do include the new item into the list. Wait the screen refresh.
The “ Default” is marked with * into the category list of items.
To modify an existing item
Select the item from the “Selection” list;
Change the “Name” description;
Click the “ Default ” if necessary;
Click on “Modify”. Wait the screen refresh.
To delete one of the item of the list
Select the item from the “Selection” list;
Click on “Cancel”;
Confirm the operation if necessary. Wait the screen refresh.
To reset all the items of the list
Click on “new”;
Wait the screen refresh.
To delete all the items of the list
Click on “Cancel All”;
Confirm the operation if necessary. Wait the screen refresh.
3.3.2.3 RTC SYNCHRONIZATION
In this section user can
decide how often to
synchronise the
controller equipped with
a real time clock.
Interval is expressed in
hh:mm. The maximum
value accepted is 12:00.
It means that every 12
hours a synchronise-
command is sent to the
controller. To enable a
controller, the user has to
go to the “Devices” page
and check the “RTC
Synchr.” checkbox.
To Next Page
Loading...