dIXEL
Manual de operare Xweb5000
3.3.1 DEVICE FIND OF THE INSTRUMENTS CONNECTED TO THE “RS485” SERIAL
LINE
The unit is capable to find the Dixell instruments connected to the RS485 serial line.
Before starting the procedure be sure that all the devices are properly connected to the RS485 line and the
corresponding addresses are properly set.
Be sure that all the instruments are properly supplied.
Be sure of the number of the instruments you are going to find to avoid losing time in counting.
To start the procedure, first select from the Configuration roll down menu the item “Stop Recording” then
“Device Find”.
The Device Find page will display the following search parameters:
Devices Class is the kind of device to find, select “Dixell Devices” for Dixell instruments
When included, the other classes will represent the instruments of other companies;
Address Range defines the address range of the research eg: from 1 to.10 means that the research
starts with 1 and finishes at 10;
Address List to find some specific addresses eg: 2, 4,34 means that the unit research only those
addresses.
After finishing click on GO button and wait for the result.
Check the total number of found instruments and compare it with the number you are expecting.
If the list does not contain one ore more expected instruments try the procedure again or try to limit the search
only to the missing address values.
Confirm the list of found devices by checking “Operation” field and pushing on Add/Replace button .
You are ready to configure the next sections of the web server.
3.3.2 CATEGORIES
This function allows defining the functioning attributes and the working features to be associated to the
instruments themselves. The user is required to preventively decide the list of these features.
Lately, when working with the Device configuration, each device can be easily configured with these
appropriate attributes.
Some categories can be defined also with “Default”. In this case the category is initially proposed as default
during the instrument configuration.
To save time and make easier the configuration procedure the parameters of the category system can be
saved and lately reloaded for any other use with the same or another server.
To Next Page
Loading...