dIXEL
Manual de operare Xweb5000
to updated the displayed parameters into the selected device;
to updated the displayed parameters into the selected devices
to save the displayed parameters into the Hard Disk of the Client PC.
To show the parameters of a device select “load from device“ from the “action” menu:
Use the filter mask to limits the range of the device selection:
To filter among the different typologies (“All” includes all the instrument);
To select the desired instrument;
To defines only a limited group of parameters to load;
To defines which is the parameter level to use (Pr1, Pr2, All).
After filling the filter mask, click on “Read” button to load the parameter from the instrument to the client pc.
The loading time depends on the number of parameter selected.
The parameter table is defined by this columns:
The parameter label as described into the instruction manual of the instrument itself;
Description of the parameter function;
Actual value of the parameter loaded from the instrument;
New value of the parameter decided by the user;
Minimum and maximum limits available for that parameter;
Parameter level of the parameter itself;
Selection box to enable the parameter saving.
To change a parameter value
To insert the desired value of a parameter click into New box.
Depending on the kind of parameter, it is possible to insert the value or select it from a drop-down list of
available values.
To confirm the new value introduced click the mouse outside the “New” box area.
It is not allowed to set a value exceeding the minimum and maximum limits. In any case a wrong value is
signalled with violet background colour of the box itself.
The user can change one or more parameters before sending back the new list.
To change the programming level
Select 1 level or 2 level under the Pr column.
To send the new parameter map to the instrument
After modifying the parameters, select “Write on Device” from the “Action” menu.
To Next Page
Loading...