XWEB5000 Operation Manual
With the bar on the bottom side of the window, it‟s possible to select the time interval that will be used to
perform the selective monitoring (during this period, the normal polling time will be increased). When
the fast sampling time will be elapsed, the data can be found on main graphs.
The right side of the windows allows selection of device resources you„ll see at maximum speed. After
doing the selection you want, you have to press the start button, the following window will appear.
Thanks to this menu, it‟s possible to decide where you want place the resources on the charts. For
example, you can place two resources in the same chart in order to do an easy comparison of the
measurement behaviour.
When the dialog “FSM stopped” will appear, the fast sampled data will be stored on the main graphs.
To Next Page
Loading...