ZENMUSE L2
User Manual
©
2023 DJI All Rights Reserved.
21
2. Tap View to open the quality report. The following uses an Area Route as an example.
a. Flight route name
b. Start and end time of the task
c. The completed ight route progress when nishing the task.
d. Display the collection time for point cloud recording.
e. Switch the displayed information between RTK and IMU.
f. Display the RTK/POS data collection time and the different status of the flight route
segments.
• The RTK status of the flight route may vary in different segments, including fixed
solutions, oating/single solutions, and invalid solutions. The oating/single solutions
is available for PPK calculation.
• Tap IMU to view the POS status of the ight route, including xed solutions and invalid
solutions.
g. Flight Trajectory
The RTK/POS status of the ight route is displayed in dierent colors. If RGB Coloring is
enabled during the ight task, the location of each photo will be displayed as a round dot
on the ight trajectory.
h. Tap to display the Edit Line/Area View. Users can draw areas on the map to mark the
segments that need recording again. Set the marked area as a mapping area and create
a new Area Route task. Tap to delete the information.
• The POS data collection time includes the calibration time before and after the task.
• If the same ight route segment is recorded by several times, the quality report will
prioritize displaying the results with low quality.
a
b
c
d
e
f
h
g
To Next Page
Loading...
