dji ZENMUSE L2 - Maintenance; Log Export; Firmware Update; Using DJI Pilot 2

ZENMUSE L2
User Manual
©
2023 DJI All Rights Reserved.
29
Maintenance
Log Export
Run DJI Pilot 2, tap HMS, then Manage Logs, and select L2 to export the log to the microSD card
of the payload.
Firmware Update
Using DJI Pilot 2
Online Update
1. Make sure that the L2 is correctly installed on the aircraft and the aircraft, remote controller,
and other DJI devices are powered on. Make sure all the devices are connected.
2. Run DJI Pilot 2, tap HMS, Firmware Update, and then Update All to update the rmware.
Oine Update
An offline firmware package can be downloaded from the DJI official website to an external
storage device such as a microSD card or U disk. Run DJI Pilot 2, tap HMS, and then Firmware
Update. Tap Oine Update to select the rmware package for the L2 from the external storage
device and tap Update All to update.
Using microSD Card
1. Make sure that the L2 is securely mounted onto the aircraft and the aircraft is powered
off. Check that there is enough free space on the microSD card and the Intelligent Flight
Batteries are fully charged.
2. Visit the Zenmuse L2 product page on the DJI ocial website and go to Downloads.
3. Download the latest rmware.
4. Once downloaded, copy the rmware le to the root directory of the microSD card.
5. Insert the microSD card into the microSD card slot of the L2.
6. Power on the aircraft. The gimbal and camera perform an auto-check and will start to update
automatically. The gimbal will beep to indicate the status of the rmware update.
7. Restart the device after the rmware update is complete.