dji ZENMUSE L2 - Maintenance

ZENMUSE L2
User Manual
32
©
2023 DJI All Rights Reserved.
Maintenance
1. Under normal circumstances, the only maintenance required for the product is to clean the
optical window of the LiDAR sensor. Dust and stains on the optical window can negatively
aect the performance of the LiDAR sensor. Make sure to regularly clean the optical window
to prevent this from happening.
2. First, check the surface of the optical window to see if cleaning is necessary. If it is necessary
to clean it, follow the steps below:
a. Use compressed or canned air.
DO NOT wipe a dusty optical window as it will only cause more damage. Clean the optical
window with compressed or canned air before wiping the optical window.
It is not necessary to use a wipe if there is no visible stains on the optical window
afterward.
b. Wipe the stains.
DO NOT wipe using a dry lens tissue as it will scratch the surface of the optical window.
Use a wet lens tissue. Wipe slowly to remove the dirt instead of redistributing it on the
surface of the optical window. If the optical window is still dirty, a mild soap solution
can be used to gently wash the window. Repeat Step B to remove any remaining soap
residue.