dji ZENMUSE L2 - Point Cloud Density

ZENMUSE L2
User Manual
©
2023 DJI All Rights Reserved.
27
Figure B: the point cloud patterns after 10 s recording by the L2 that is installed on the aircraft. The
relative altitude is set to 150 m and the ight speed to 10 m/s.
Figure B
Figure A
Point Cloud Density
The point cloud density will vary depending on the ight altitude, ight speed, and point cloud
overlap. The gure below shows the variation of point cloud density with the ight altitude and
flight speed when the point cloud overlap is 0%. The point cloud density is 76/m² when the
sampling rate is set to 240 kHz, ight altitude to 150 m and ight speed to 15 m/s.
Density/m
2
Point Cloud Density
Speed (m/s)