ZENMUSE L2
User Manual
©
2023 DJI All Rights Reserved.
5
Product Prole
Introduction
The ZENMUSE
TM
L2 integrates a LiDAR module, a high-accuracy IMU, and an RGB mapping
camera on a 3-axis stabilized gimbal, which can be used with specied compatible DJI
TM
aircraft.
With Point Cloud LiveView, users can take a quick view of the 3D point cloud eect in the DJI
PILOT
TM
2 app. When used with DJI TERRA
TM
, the L2 oers a complete solution that generates
point cloud output and extracts ground points to generate DEM results, which efficiently
completes highly accurate reconstructed models of complex structures.
Overview
1. Gimbal Connector
2. Pan Motor
3. Roll Motor
4. Tilt Motor
5. microSD Card Slot
6. RGB Mapping Camera
7. LiDAR
Installation
The L2 can be mounted to MATRICE
TM
300 RTK (requires DJI RC Plus) or Matrice 350 RTK aircraft.
1. Remove the gimbal cap and lens cap.
1
2
3
4
5
6
7
To Next Page
Loading...
Need help?
General
