Otherwise, the rotor may be moved off while rotating and cause damage of the centrifuge and rotor.
⚫ Firmly tighten the rotor door with rotor.
8. Operation
CAUTION：
⚫ Do not push or lean against the centrifuge while it is running.
⚫ Do not run the centrifuge when fragments or sample solutions are left in the centrifuge chamber.
Always keep the centrifugal chamber clean.
⚫ If the centrifuge makes strange noise during operation, stop it immediately and contact our service
center. Notify them of the warning code if displayed.
8.1 Normal Operation
Turn on the power switch, centrifuge will start self-diagnostic checks, see figure 8-1 below:
HELLO 88 ℃ 88 min
Figure 8-1 Self-checking interface
After self-checking, instrument will display accumulative running time, see figure below:
00312 56 45
Figure 8-2 Accumulative running time interface
Figure 8-2 indicates the centrifuge has accumulated running time 312 hours 56 minutes and 45 seconds, and
then the centrifuge displays the last running values, see figure 8-3 below:
To Next Page
Loading...
