DLab DM0506 - 8.1.3. Starting and Stopping the Centrifuge

◼ The parameter increases or decreases in a cyclic way. Turn the knob clockwise or
anticlockwise to increase or decrease the adjusting parameter values. If you continue
rotating the knob when the parameter hits the upper limt, it will start from the lower limit
again.
(2) Set the run time
◼ Press the parameter key to select the time parameter and wait until its value blinks.
◼ Rotate the knob and set the timer to desired setting within the range of 30s-99min.
◼ Set the timer to HD to disable it and run the centrifuge in a mode without time limit.
(4) Modify the predefined program
◼ Press the program #1 key (or program #2 key ) to load the settings of this
predefined program. Press it again and hold it for 5 seconds to edit the settings. Press it
again and again to cycle between speed, RCF and timer setting. Rotate the knob to adjust
the parameter of current setting. Wait for 7 seconds and the settings will be updated for the
corresponding predefined program.
8.1.3. Start Run
(1) Press the key to start running.
◼ The rotor will start rotating only when the lid is locked.
◼ Timer starts to count down as soon as the speed reaches the set value.
(2) Inquire and change the settings
◼ The setting can be modified when the centrifuge is running at the set speed.
◼ Press the knob to go back to settings screen. Follow the instructions in 8.1.2 to review and
modify the settings. Wait for 7 seconds, the settings will be updated, the display will go to the
running screen again and the centrifuge will run on the new settings.
◼ The timer will continue to count down without reset.
(3) Error message
◼ The centrifuge will automatically stop if any failure occurs while running, with the error
code shown in the timer section on the LCD display. Please look up the cause of failure and take
appropriate action in Table 10.1.
8.1.4. Stop running
(1) When the time is up or you press the Start/Stop key while running, the centrifuge
will stop running.
◼ The centrifuge will beep to notify the user when the rotor fully stops.
(2) The lid lock will be released when the rotor fully stops.