15
7.5 Symmetrically load centrifuge tubes in rotor
CAUTION
⚫ Make sure the rotor lid is securely fixed on the rotor, as well as the rotor and
shaft are tightened. Otherwise, the rotor may be moved off while rotating and
cause damage of the centrifuge and rotor.
⚫ Firmly tighten the rotor door with rotor.
CAUTION
⚫ Do not push or lean against the centrifuge while it is running.
⚫ Do not run the centrifuge when fragments or sample solutions are left in the
centrifuge chamber. Always keep the centrifugal chamber clean.
⚫ If the centrifuge makes strange noise during operation, stop it immediately
and contact our service center. Notify them of the warning code if displayed.
8.1 Normal Operation
Turn on the power switch, centrifuge will start self-diagnostic checks, see figure8-1
below:
Figure 8-1 Self-checking interface
To Next Page
Loading...
