DLab DM0636 - Consumables; The Replacement of Rotor Seal Rings

25
⚫ The rotor should be regular maintenance, recommend to cleaning it each 3
months to ensure tube and rotor holes keep clean, and then apply a thin coat of
silicon grease.
9.2 Consumables
Replaceable wearing parts listed below. It is recommended to replace these
according this table.
Item.
Replacement parts
Replacement conditions
1
Rubber block of temperature sensor
Cracked
9.3The replacement of rotor seal rings
9.3.1 Instructions
There are three high-temperature rubber seal rings that equipped into rotor to
achieve bio-safe. The seal rings may fall off or aging after several autoclaving, need
to be replaced or re-installed.