DMP Electronics XR150FC User Guide

10 XR150FC/ XR550FC User’s Guide System Setup
Reset t ing t h e Sensor s
1. Access the User Menu.
2. Press COMMAND until SENSOR RESET displays.
3. The keypad displays SENSORSOFF for Àve seconds followed
by SENSORSON.
4. The keypad automatically exits the User Menu.
L ckd
Locks all Public Doors from the keypad in an emergency situation.
Usi g L ck d
1. Access the User Menu.
2. Press COMMAND until LOCKDOWN?displays.
3. Press any Select key. The door access relay is activated and
all Public Doors are locked.
4. Press COMMAND to return to the Status List display.
D r L ck/ U l ck
Locks and unlocks doors from the keypad.
Usi g D r L ck / U l ck
1. Access the User Menu.
2. Press COMMAND until DOORLOCK/ UNLOCK?displays.
3. Enter the door number and press COMMAND.
-OR-
Press the fourth Select Key to browse door names. Use the
COMMAND key to scroll through names and press any Select
Key when the desired door is displayed.
4. Press the Back Arrow key to return to the
DOOR LOCK/ UNLOCK?display.
Alarm Sile ce
Silences the alarm bells or sirens during an alarm.
Alarm Silence allows you to turn off the alarm bells and sirens
connected to your system duringan alarm. UsingAlarm Silence does
NOT stop an alarm report from being sent to the central station and
does not reset any alarmed devices. Use the Sensor Reset function
to reset devices such as smoke detectors that latched in alarm.
Note: The keypad tone silences as soon as the Àrst user code digit
key is pressed. You can also silence an alarm by entering your user
code and pressing COMMANDor by presenting your card to a reader
while the Status List displays. If using a p roximity card, areas
assigned to your card may be disarmed and door access occurs.
Usin g t he Alar m Silen ce Funct ion
1. Access the User Menu.
2. The keypad displaysALARM SILENCE?.
3. Press any Select key to silence the b ells and exit the User
Menu.
Se s r Reset
Resets smoke or glassbreak detectors. Also clears Fire/ Supervisory
alarm and trouble displays.
Sensor Reset is used to reset smoke and glassbreak detectors after
they have tripped. Once these detectors trip, they must be reset
before they can detect any additional alarm conditions. When you
select Sensor Reset, power to the detectorsis temporarily removed
by the system allowing them to reset.
Make sure all smoke is cleared from around the smoke detector
areas b efore performing a Sensor Reset to prevent the alarm from
occurring again.

DMP Electronics XR150FC Specifications

General

Brand	DMP Electronics
Model	XR150FC
Category	Control Panel
Language	English