DMP Electronics XR150FC User Guide

Appendix B XR150FC/ XR550FC User’s Guide 27
Appe dix B
Z e Status Br ser
ZONE STATUS?
ARM BYPS ALR NBR
ZONE NO: -
SELECT ZONE . . .
Access the User Menu.
Press COMMAND until
ZONE STATUS appears.
Press any SELECT
key/a rea then SELECT
NBR.
SELECT AREA . . .
FRONT OFFICE
24 HOUR ZONES
Press one of the left two
SELECT keys/areas to
browse through the
programmed zone names .
When the area where the zone is
located displays, press any
SELECT key/area.
This prompt allows you to search
for a zone by area. Press the
COMMAND key to scroll through
the list of areas.
After all the areas d isplay, the
system allows you to search
through the 24 hour zones
(Fire, Panic, Supervisory, etc.)
Press the COMMAND key to scroll
through the zone names list.
EAS T DOOR
When the correct zone name
displays, press any SELECT
key/area.
ZONE NO : 0 1 2
Verify the zone number matches
the previously shown name.
CMD
EAST DOO R -OKAY
The system dis plays one of these
zone status messages
:
-OKAY = the zone is normal
-BYPAS = the zone is bypassed
-BAD O = the zone is open
-BAD S = the zone is shorted
Press COMMAND.
SELECT ZONE . . .
HALL SMOKE
ZONE NO : 0 3 4
HALL SMOKE -OKAY
Press COMMAND.
When the correct zone name
displays, press any SELECT
key/a rea.
Verify the zone number matches
the previously shown name.
Press COMMAND
to e nter another
zone number.
The system di splays one of these
zone status messages:
-OKAY
= the zone is normal
-BYPAS = the zone is bypassed
-BAD O = the zone is open
-BAD S = the zon e is s horted
CMD
CMD
CMD
CMD
CMD
CMD
CMD
CMD

DMP Electronics XR150FC Specifications

General

Brand	DMP Electronics
Model	XR150FC
Category	Control Panel
Language	English