DMP Electronics XR150FC User Guide

System Setup XR150FC/ XR550FC User’s Guide 23
Ambush Codes
Your system may be programmed to allow user number 1 to be
used as an Ambush code. ThisAmbush code functions identically to
a standard code with the exception that it sends a silent alarm to
the central station. Thissilent alarm alertsthe operator to a duress
situation at the premises and prompts immediate notiÀcation of
authorities.
Refer to the System Setup section of this guide to see if your system
is programmed for Ambush. If so, do NOT p rogram a code for user
number 1 unless you intend to use the Ambush function.
Display Eve ts
Allows you to review up to 12,000 past door access and system
events. There are six event types:
Zone Activity - Zone alarms, troubles, and restorals.
User Code - Adding, deleting, and changing user codes.
Supervisory - Problems with system hardware components.
System Monitor- Problems with AC Power, Battery, phone line or
tamper problems.
The system memory holds a maximum of 12,000 past events for 45
days. Any event older than 45 days automatically clears from the
system memory. Also, once the full 12,000 events are stored, any
new event causes the oldest event to be cleared. See Appendix A
for Display Events.
Service Request
Your user code proÀle may be programmed for Service Request.
This User Menu feature allows you to simply press any top row
Select key when SERVICE REQUEST? displays and have the system
automatically send a “ Request for Service” message to the central
station. The display changes momentarily to REQUEST MADE to
conÀrm your request was sent.
Fire Drill
Fire Drill is used to test the Àre bells or Àre horns in your system.
The Fire Drill test turns your system bell circuit on, but does not
send a message to the central station.
St ar t i g a Fir e Dr ill t est
1. Access the User Menu.
2. Press COMMAND until FIRE DRI LL?displays. Press any Select
key.
3. The keypad displays SURE? YES NO.
4. Press the Select key under YESto start the Fire Drill test.
E di g a Fir e Dr ill t est
1. Enter your code at the keypad and press COMMAND to end
the Fire Drill.
2. The Fire Drill test automatically endswith ALARMSILENCEor
the programmed Bell Cutoff time.

DMP Electronics XR150FC Specifications

General

Brand	DMP Electronics
Model	XR150FC
Category	Control Panel
Language	English