System Setup XR150FC/ XR550FC User’s Guide 11
D r Access
Operates an electric door strike from the keypad.
Note: The door strike function is not available on Clear Touch™
keypads or the Model 7872 Graphic Touchscreen keypad.
Door Accessisused to operate the door strike relay that is built into
some keypads. Power for the door strike is connected to the keypad
relay and can be interrupted by using the Door Access function.
When Status List displays, you can operate Door Access by simply
entering your user code and pressing COMMAND. See Easy Entry™
User’s Guide in Appendix E. I f you are using a keypad that has a
built-in card reader, you may simply present your card to be
allowed Door Access.
Note: Your system may be pre-programmed at installation to
transmit a d oor access report to the central station.
Usin g t he Door Access
1. Access the User Menu.
2. Press COMMAND until DOORACCESS?displays.
3. Press any Select key. The door strike relay turns on
momentarily.
4. The keypad returns to the Status List display.
o utputs o o ff
Allowsyou to manually turn the system or door accessrelay outputs
ON and OFF.
This function is used to individually turn your system relay and
access door outputsONand OFF. Your system may use these outputs
to control door access, interior and exterior lighting, heating, air
conditioning, or other appliances.
The namesand numbersof the relaysconnected to your system are
located in the System Setup section of this guide.
Outputs can be turned ON or OFF regardless of the output settings
in Schedules.
Your system may be programmed to require that your user code
proÀle have access to areas assigned to the keypad. INVALIDAREA
displays when your user code does not have access to the keypad’s
areas and the output does not turn on.
Under certain conditions, some outputs cannot be turned
on. If you select a restricted output, the keypad displays
CANNOT TURN ON.
To Next Page
Loading...
Need help?
General
