1-3
EN
Before installation
• Read and understand this manual, and any other manuals supplied with
this system.
• Ensure you have all the required components on hand before you start.
• Do not use a wheel-mounted trim switch with coiled cord. The cord can
wrap around the steering wheel shaft and inhibit steering.
During installation
• Install components as instructed in this manual. Some component parts
and kits may contain additional installation instructions – refer also to
those instructions.
• Do not substitute any component of the system. Dometic and Optimus
parts are rigorously engineered and tested to ensure system integrity.
Substitution of components may compromise safety, performance, and
reliability.
• If an instruction is unclear, contradictory, or you are otherwise unsure how
to proceed, do not guess. Contact Dometic Marine technical support.
After installation
• Perform the system inspection and interference checks described in
section 3.1.1 and 3.1.2.
• Correct any interference issues before handing the boat to the owner.
1.3
Safety considerations for installers
WARNING!
Optimus EPS with Electric Actuator must be installed by an authorized
dealer or OEM boat builder.
WARNING!
Failure to comply with these instructions may result in a loss of steering
control, which could lead to a collision and/or ejection from the boat,
causing property damage, personal injury, and/or death.
To Next Page
Loading...
