Profeller Shaft and Differential
PD-24
13.Tighten the left and right gasket of half shaft bear-
ing one by one and measure the windage and preload force
of driven gear. Tighten the left and right gasket in turns to
get the prescripive windage and preload force.
When check preload force, turn the drive conic gear
repeatly to lay bearing in the right position.
14.Tighten the bolt of half shaft bearing's seat.
15.Assembly lateral locking pin.
16.Check the radial run-out of main reducer driven
gear (by micrometer).
If the difference of clearance on different position is
great, it may caused by other reasons beside driven gear
and differntial.
If the radial run-out amont of driven gear is inner the
prescriptive range while the clearance of differential hous-
ing on different position is great, replace the drive and
driven gear or differential housing.
17.Check gear contact area (refer to the explanation of adjusting).
To Next Page
Loading...