Clutch
CL-9
·Check whether the matching surface of the pressure plate and driven disc
has deformation or damage. Change them if necessary.
·Adjust the unevenness of the diaphragm spring with tool.
Flywheel check
·Check whether the working surface of the flywheel is burnt or discolored.
Remedy it with the emery paper.
Check its surface for planeness.
Clutch cover and flywheel
When assemble the clutch pressure plate and driven disc, insert the special
tool into the spline hole of the driven disc. (using for central position)
·Tighten the fixed bolts the clutch cover.
·Tighten the bolts as cross procedure shown in the figure with two steps.
Service Data and Specifications
Clutch driven disc
Outside diameter: 260mm
Thickness: 8.0 ± 0.3mm
Checking and adjusting
The datum measured is referred to distance between the floor surface and
the pedal.
Clutch driven disc
Clutch pressure plate
Diaphragm spring height: 41-43mm
Pedal height 160~170
Pedal free travel 30-50mm
Wear limit form the friction surface to the
rivet head
0.3mm
Effective thickness of the friction lining 1.2mm(Nominal size)
To Next Page
Loading...