Steering System
ST-4
·When installing the steering wheel, apply a layer of multi-purposed
grease on the whole surface (two parts) of the automatic return-back pin of
steering indicator and touch point of the horn.
·Install the steering wheel on the column shaft at the central position.
·After installing, turn the steering wheel, make sure to have a smooth
movement and the same turning cycles on both left and right side at the
central position.
Steering Column
·When fixing the steering column, first screw all the lock bolts of lower
bracket and clips with hands, and then re-tightening again to make sure no
extra pressure will apply to the steering column.
·When fixing the steering spline shaft, make sure that the tightening bolts
and the sunken part of the shaft are correctly faced to each other.
Disassembly and Assembly
·When assembling and disassembling, turn on the steering lock with the
key.
·Be sure the surface of the spring lock ring after installing faces with the
shaft.
·Before putting the shaft into the sleeve, install the spring lock ring.
To Next Page
Loading...