Steering System
ST-5
·Install the spring lock ring on the upper shaft with tools.
Steering Lock
a) Remove the lock screw with a clamp.
b) Tightening the lock screw.
Notes:
Pay attention to whether the position of the steering lock mechanism is
correctly located.
Adjusting the Mechanism
·After installing the steering column, check the movement of the adjusting
mechanism.
Front, Rear
L1: 15mm
L2: 45mm
Upper, Lower
L3: 10mm
L4: 20mm
Check
·If the steering wheel could not turn smoothly, check the steering column
from the following aspects, and replace relevant damaged parts.
Check whether bearing of the steering column is damaged or uneven,
lubricate it with recommended common grease. If necessary, replace the
steering column assembly.
Check whether the sleeve is deformed or damaged, replace it if necessary.
If the vehicle is hit a little, check the dimension of L. If the L value is ont
in the required range, replace the steering column. L: 484mm
To Next Page
Loading...