Front suspension
FA-19
4.Install the torsion bar spring
When install the torsion bar spring, please pay atten-
tion to the mark on the end of the spring. Don't install in
wrong direction.
5.Install the adjusting arm
Make sure the vehicle is in no load.
Make the same extending length of the fixed bolt and
the extending length before disassembling, and then
screw down.
Tighten or loose the adjusting nut to adjust the
vehicle gesture, and before tightening, there should be
loose first and then tighten up as required.
After adjusting the vehicle body gesture, tighten the
locking nut to the required torque.
Tightening torque: 108~127N.m
6. With the wheel on ground (vehicle no load), shock
the vehicle to eliminate the friction force of the suspension
parts.
7.Measure the vehicle gesture H
H=A-B mm (no load)
See "Maintenance data & explanation" for reference.
To Next Page
Loading...