Brake System
BR-3
Exhaust
Note:
Monitor the level of the liquid in process of exhausting.
Add new liquid of "901-4" in to the reservoir to assure
it is always full during the whole process.
Place a container under the main pump to avoid liquid
coming out.
1.Use a nylon pipe to connect the exhaust valve.
2.Depress the pedal to the end several times.
3.Maintain the pedal at the end, loosen the valve to exhaust.
4.Tighten the exhaust valve.
5.Release off the pedal slowly.
6.Repeat the 2-5 steps until pure liquid flowing out of the
exhaust pipe.
Exhaust following the steps below:
Left rear wheel → right rear wheel → left front wheel →
right front wheel
To Next Page
Loading...