Front suspension
FA-14
Steering Knuckle
Disassembly
Use special tool to dismount the steering tie-rod.
Install the check nut on the check bolt in reverse to
protect the bolt.
Dismount the steering knuckle from the ball head
connecting part.
(1) Loose (Don't dismount) the upper and lower ball
head pin clamp nut.
(2)Dismount the steering knuckle from the upper
and lower ball head connecting part by special tool.
Never screw off the loose nut in step (1).
(3)Screw off thelock nut of ball head pin, and lift the
lower transverse arm by the jack.
(4)Dismount the steering knuckle from the upper and lower transverse arm.
To Next Page
Loading...