Steering System
ST-1
Steering System
Notes
·Before disassembling, please clean external surface of the parts carefully.
·Disassemble the parts in a clean working area to prevent any dirt and other objects from entering.
·Put the disassembled parts in order for later reassembling.
·Clean the parts by using nylon or soft paper, normal shop cloth will cause some remains on the parts to interfere
the movement.
·Before check or assembly, clean all the parts carefully with liquid.
·Before assembly, it is better to apply a layer of oil used for auto transmission on the surface of hydraulic parts,
and apply a layer of vaseline on the O-type oil seal instead of lithium lubricanting grease.
·Replace all the washers, oil sealing and O-type rings to avoid using damaged washers, oil sealing and O-type
rings in assembling. After the assembly, proceed a test-run for property.
Special Maintenance Tools
Tool Name Brief Description
Pulling tools, steering wheel
Disassemble the steering wheel
Ball connection separator
Release the ball connection
Pulling tools, steering arm spanner
Disassemble the steering arm
Lock nut wrench
Spanner, adjusting screw
Adjusting and tightening the lock nut
Torque spanner
Measuring the torque
To Next Page
Loading...