General
GL-2
Preventive Measures
See preventive measures below to get safe operation and suitable mainte-
nance surely. These measures will not be repeated in the next pages.
1.Do not let engine run too long absolutely unless it is under special venti-
lation to ensure that there is good ventilation in working area, no fire
things there.
Be careful sternly the any burnable, poisonous things like gasoline, refrig-
erant etc are used.
Working in a ditch or close environment and contacting any dangerous
things, it is necessary any dangerous things,it is necessary to provide good
ventilation in the working area, and smoking is prohibited there absolutely.
2.When truck is lifted, use a wheel stationary block to stop the truck move.
After lifted, used a safe mat to support the truck on a specially designed
point of truck to bear the truck weight, then begin its maintenance.
These operations should be completed on an even ground.
3.Being unfixed a heavier assembly like engine, gear box or rear axle, be
careful to keep it balance, avoid it fall down. And not permit to damage
the details next to the brake pipes, etc.
4.Working at some maintenance without battery, turn off the ignition
switch and power switch at first, and then take off the negative line on
the battery to avoid unexpected accident happening like short circuit.
5.To prevent serious burnt accident, avoid touching some hot metal, such
as radiator, exhaust manifold and muffler etc. When a engine is hot, do
not take off the lid of radiator absolutely.
6.Before maintenance, use the suitable cloth to cover the inner ornaments
and ground mat of the truck, in order to keep it in a good condition.
Note:
Be careful not smash the painted surface of the truck.
To Next Page
Loading...